Use and Care Manual

Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [e-mail]
Page 18
41. Attach Interior Door Stop to Floor with 2 - 1 1/4” screws. To align correctly, close Doors in best
close Door position. Mark and attach. Drill pilot holes to prevent splitting.
42. Install the Barrel Bolt Plywood Spacer 3/4” from bottom of the Right Door with 2 - 1” screws. Position
the Interior Silver Barrel Bolt on the Plywood Spacer and use 3/4” Silver screws supplied in Hardware
Package to attach. Tap barrel on Interior Door Stop to mark location. Open Door and Drill with a 3/8” bit.
Right Door
43. Attach Door Handles (DD). Handles are positioned on top section of each door and mounted with
3/4” Black Screws. Attach Black Barrel Bolt (EE) as illustrated above with 3/4” Black Screws.
Note how female part of Barrel Bolt is positioned higher than male. Do a dry run first to position Barrel
Bolt correctly. Important - Drill pilot holes with 1/8” drill bit prior to securing with screws to prevent
wood splitting.
Mark first and
then drill hole
with 3/8” bit.
Important: Drill shallow Pilot
Holes to prevent splitting
Install 3/4”
from bottom
of Door.