Use and Care Manual

Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [e-mail]
Page 18
33. Position Rafter so end is flush with Corner Post and Outside Polygal Angle Cut Window
slides into dado cut of Rafter. When orientated correctly, start 2 - 6” Lag Screws with 3/8” Washer
with a hammer and tighten with 9/16” socket.
6” Lag Screws with Washer.
Flush
34. Locate Part M - Top Triangular Polygal Windows. Slide Window in Top Cap gap and into
dado cut of Rafter.
35. Locate Left Side Rafter and orientate as shown above. Once Outside Polygal Angle Cut
Window is sitting in dado cut of rafter, carefully slide Rafter up.