Use and Care Manual

Do Not Attach Walls
To Floor Until Step 26.
17. Position rear solid wall into
place on plywood floor. Butt both
vertical wall studs of side and rear
walls together and attach with
3 - 2.5” screws. Screw at the
bottom, middle and top of stud to
secure properly.
Rear Wall Panels
Rear Solid Wall
Side Solid Wall
18. With the corner wall
attachment complete, position
remaining rear wall panel in
place so bottom 2x3 wall
framing is sitting flush with
outside floor joists and plywood
floor. Wall siding should
overhang floor by approximately
1/2”
When positioned correctly,
attach both wall panel studs
together as per Step 17.
Rear Solid Wall
2x3 wall framing flush
with outside of plywood.
Be sure that rear
wall panels fit
between the side
wall panels.
(sandwiched)
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [e-mail]
Page 9
Optional - Caulking
seams will help prevent
moisture from entering at
seam.
Caulking not included in
kit.