Use and Care Manual

40. From the inside of playhouse,
complete securing the Front and
Rear Roof Panels that were
previously tacked down in
Steps 37-38. Place an additional
4 - 2 1/2” screws per side from top
wall framing on an angle up into roof
plywood.
41. Using 2” screws, secure Porch Roof Panel to each Porch Rafter from underneath.
IMPORTANT: Make sure screws
are angled so they are concealed
completely into the Ridge Beam.
Exposed screws could seriously
harm a child or adult while standing
up inside unit. Do a physical
inspection inside the playhouse for
all exposed screws and remove as
required at this point.
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [e-mail]
Page 18
42. To complete Roof Section,
attach Front and Rear Roof Panels
from the top into the Roof Ridge
Beam with 3 - 2 1/2” screws per
panel.