Use and Care Manual

57. Attach Door Handle and Interior Barrel Bolt to door with hardware provided. When mounting
Interior Barrel Bolt, align door with Narrow Wall framing and position Barrel Receiver accurately.
53. Score/cut 1 Ridge Cap to 12” or to fit in the center of roof.
54. Attach center Ridge Cap with 4 - 1 1/4” Shingle
Nails.
55. Position Bottom Door Panel in door opening.
Framing of door should be flush with Door Jamb.
Leave a 1/4” gap between floor and Bottom Door.
56. With Bottom Door correctly positioned, attach
Hinges to Door Jamb and Door Framing with
3/4” Silver Screws. Before completely securing all
screws, check door alignment by opening and closing
door. Adjust hinges as necessary.
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [e-mail]
Page 22
Carefully score or cut Ridge
Cap end with Utility Knife.