Installation Guide

17. Lift and position completed short Bed Rib Frame and
place between side and interior panel siding. Do not center
on panel framing. Align with bottom of panels. Secure with
6 - 2” Screws per plate. Pre-drill to prevent Splitting.
Important - Do not over screw! Complete both sides.
19. Lift and center completed longer Bed Rib Frame on rear and end interior panels. Align with
bottom of panels. Secure with 6 - 2” Screws per plate. Important - Do not over screw!
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [e-mail]
Page 11
6 - 2 “
Screws.
18. Complete remaining short Bed Rib
Frames (5) as per Step 17.
Do not align connection
plate on vertical wall
framing. Offset as shown.
Flush with
bottom.
Note that connection plate is
offset from inner panel joint.
Connection plate is aligned with panel joint
on rear of Garden Bed only.