Instructions / Assembly

45. Roof Gussets are positioned on middle rafters. Prior to attaching, make sure Side Walls are
properly aligned. Have two helpers push the front and rear walls at the top from the outside of shed
until inside to inside measurement between Side Wall Plates is 91”. When correct, slide gusset up,
use level to square gusset and attach to rafters with 4 - 2” screws. Complete remaining Gussets.
91” across
47. Identify Roof Panels. There are 2 Outside and 1 Middle Roof Panel per side. Starting with
outside rear panel, lift up and place on rafters.
Shingles overhang plywood
on outside panels.
Shingles and plywood
flush on middle panel.
Roof facing down
Outside Roof Panel.
46. Secure Rafters to Top Wall Framing
with one 3” screw per rafter. Screw through
Wall Frame at an angle. Have two helpers
push the Front and Rear Walls at the top from
the outside of shed until inside to inside
measurement between the Top Plates is 91”.
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [e-mail]
Page 20