Use and Care Manual

15. Starting at Rear Corner, position a
Solid Wall Panel on top of plywood floor.
The Wall Panel bottom framing will sit flush
with floor framing. Wall siding will overhang
the floor by 1/2”.
Important: Make sure all walls are
aligned in their upright position. If not,
water may leak into your shed. Unsure if
panel is facing up or down? Check and
compare siding on window wall panel to
match alignment.
16. The side wall panels will sit flush with floor
framing at corners, and the rear panels will be
sandwiched between them. Note: Siding will
overhang the floor by approx. 1/2” .
Outside 2x3 framing of wall panel is
flush with outside of floor framing
when properly aligned.
Side Panel
Rear
Bottom Wall Plate
14. Starting with Solid Wall Panels, carefully lay panel face down. Position and attach Wall Plate
to bottom of wall studs of each wall panel with 3 - 2 1/2” screws. Position so plates are flush with
framing.
Front of Shed
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [e-mail]
Page 8