Use and Care Manual

28. Position the Rear Top Plates on rear wall top framing to complete. Use 4 - 2” screws per piece.
27. Next, attach the 4 Side Top Plates (2 per side). The side top plates are angle cut down the
length. Once again, position top plate on wall plate so it is flush with inside of wall plate. Side plate
should also be flush with Front Top Plate. Secure with 4 - 2” screws per piece.
Side Top Plate
Rear Top Plates
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [e-mail]
Page 13
29. Locate Gable 1/2 Walls for both sides of the
shed. Align framing and wall siding lapp together.
Screw center wall framing of each piece together
with 3 - 2 1/2” screws. Note: prior to attaching, try
each combination of Gables for best fit.
Notched at top
Flashing
Male / Female
Wall Lapp Siding
Plate flush to inside
of wall framing