Instructions / Assembly

22. When all walls are attached together,
check alignment with the floor. Bottom wall
plates should sit flush with outside of floor
frame. When positioned correctly, fasten
bottom wall plates to floor using 4 -2 1/2”
screws per wall panel.
Wall Plate
23. Position angle cut Rear Top Plates on
top of wall studs so they are flush on the
inside with 2x3 wall stud. The Top Plate is
comprised of 3 pieces (2 outside pieces with
an angle cut on one end and a center piece
that is straight cut). Attach by screwing down
into top wall plate with 4 -2” screws each.
Angle cut
on ends.
Top Plates should be flush
with inside of wall framing.
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [e-mail]
Page 11
32” wide
Confirm 32” Wide Door Opening at Bottom
Optional: Caulking seams will help
prevent moisture from entering at
seam. Caulking not included in kit.
Caulking
Angle
screws into perimeter
Floor Joists.