Instructions / Assembly

37. Position the Rear Gable Wall on top of
the Rear Top Plate. The rear gable framing
should sit flush with the inside of the top plate.
It should also be centered sideways on the top
plate. Hint: use a straight edge to check the
angle of the gable framing and top plate. Both
angles should line up. Adjust gable
accordingly. Temporarily attach to walls and
Top Plate with 2 - 2” screws. Gables may need
slight adjustment in Step 51. Complete
attachment in Step 51 with additional 6 - 2”
screws. Screw from the bottom of gable
framing down into Top Plate and Wall.
39. Position the Middle Gable Wall on top of front top plate. Middle gable has cedar siding on the
front that is cut flush with gable framing. Once again, the framing of the gable should be flush with
outside of plate and be centered sideways on the plate. When in correct position, attach with 2 -2”
temporary screws as per Step 37. Later in Step 51, complete attachment with 6 more 2” Screws.
38. Locate both Middle Gable Walls and attach together as per Step 33.
Siding is
flush with
framing
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [e-mail]
Page 16
Gable Notch