Users Manual

o Device keeps information about the current antennas configuration and operating
mode in external non-volatile memory and returns to the last configuration/mode
after power up. See “External Memory Map” and “App’s settings” sections
● 0x003F – RFID read request
● 0x0040 – RFID reading
The complete details about the Outform Device Communications (ODC) protocol are available
in the ODC spec document.
Emissions and Immunity
The device will adhere to the Outform emissions and immunity standard
Future Builds
In the future for 2nd generation, we will add several new features
● Add passive and active modes
● 8 ports and 16 ports for antennas
● Automatic ODC addressing using DHCP
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.