User's Manual

Step 1. Press the left side of the cover
inwards to lever the cover open.
Step 2. Use your finger to power the
interactive riser o.
Step 3. Remove the 2x butterfly nuts
by hand and put them to one side.
Step 4. Remove the plate and put it to
one side.
Updating the Joplin
Page 8
Updating the Joplin
Page 9
Step 5. Lift the display away from the
table.
Step 6. Insert the USB into the correct
port (depending on what side the joplin
is installed).
Step 7. Insert a rod through the hole
located in the base of the display to
press the reset button on the riser. Press
and hold the reset button.
Step 8. Power on the riser. In about
10 seconds 2x white LED’s on top of
the devices turn on. Release the reset
button once the 2x LED’s are on. After
a few seconds 4X white LED’s show.
After a few more seconds the LED’s go
blank. The flashing is in process. o
nce
the flashing is finished, one of the
following two things will happen:
1. If flashing is successful, all LED’s
will glow green. If flashing fails,
all LED’s glow red. If this happens,
restart the process. If red LED’s still
show then there is an issue with the
software on the USB. Reboot the
riser with the newly flashed sofware,
by powering o then back on.