Power Amplifier Owner's Manual 200 M-Block

ManualsBrandsOutlaw Audio ManualsAmplifier200 M-Block

Owner’s Manual

Model 200 M-Block

Power Amplier

Summary of content (12 pages)

PAGE 1
Model 200 M-Block Power Amplifier ® Owner’s Manual
PAGE 2
Owner’s Manual Warnings Please Read First CAUTION: To reduce the risk of electric shock, do not remove the cover (or back). No user serviceable parts inside. Refer to qualified personnel. WARNING: To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture.
PAGE 3
Owner’s Manual Unpacking Table of Contents 3 Model 200 M-Block Power Amplifier 3 Features 3 Unpacking 4 Front Panel and Rear Panel 5 Installation and Configuration 5 Power Control Connections Speaker Wire Connections Model 200 Connection Diagram Audio Signal Connections AC Power Connection 5 6 7 7 7 Operation 8 Care and Maintenance 8 8 8 8 8 8 9 9 Cleaning Troubleshooting Guide Protection Circuitry Fuse Replacement Outlaw Service Information Troubleshooting A Few Words About Hum and Noise
PAGE 4
Owner’s Manual Front and Rear Panel Front Panel and Rear Panel �� A �� B A C D E F Green: Indicates that the Model 200 is on and ope
PAGE 5
Owner’s Manual Speaker Wire Connections IMPORTANT NOTE: Do not make any change to this switch setting unless the ac power cord is removed from the unit so that the amplifier is totally disconnected from any ac power source. H AC Power Switch Model 200. Connect the other end to a matching jack on the device that will be provide a 6 to 35 volt signal when the unit is to be turned on. 3.
PAGE 6
Owner’s Manual Model 200 Connection Diagram Model 200 Connection Diagram �� Cables with a g
PAGE 7
Owner’s Manual Operation If you are using spade lugs, connect them to the wire using the manufacturer’s instructions, and then loosen the caps on the speaker terminals. Place lugs between the plastic cap and the back of the terminal, as if it were a horseshoe on the game’s post. Again, remember to observe proper polarity. Tighten with your fingers to obtain a positive contact.
PAGE 8
Owner’s Manual Care and Maintenance Care and Maintenance Cleaning When the unit becomes dirty, wipe it with a clean, soft, dry cloth. If necessary, first wipe the surface with a soft cloth slightly dampened with mild soapy water, then with a fresh cloth dampened with clean water. Wipe dry immediately with a dry cloth. NEVER use benzene, thinner, alcohol or any other volatile cleaning agent. Do not use abrasive cleaners, as they may damage the finish of the metal parts.
PAGE 9
Owner’s Manual A Few Words About Hum and Noise Ground Loop Diagram Coax Cable Set-top Box Cable Feed 60Hz AC Ground Loop A/V Cables 60Hz AC Ground Loop AC Line AC Line AC Ground Main House Grounding A Few Words About Hum and Noise Audible hum, or a discernable low frequency noise, is one of the most common problems in audio/video systems. This hum, which may be present even when the volume is at a low level or when the power is off, is usually caused by a problem known as a “ground loop”.
PAGE 10
Owner’s Manual Specifications Warning: if you suspect that the grounding system in your home’s electrical wiring is causing the hum problem, it is important that you do not make any changes to the wiring yourself. Only a licensed electrician should make any changes to household wiring, and they must be made in full compliance with all local building, safety and electrical codes. Suggestion #4: Faulty earth grounds may also cause hum in your home’s electrical system.
PAGE 11
Owner’s Manual Outlaw Audio Limited Warranty The Outlaw Audio 30-Day Satisfaction Guarantee This product is guaranteed to satisfy all your needs for a high performance power amplifier. If for any reason, you are not completely satisfied with it, please contact us at 866-OUTLAWS (688-5297) within 30 days of receipt of the unit and you will receive a return authorization. Please save all of your packing material in that the amplifier is heavy and can get damaged in shipping without proper protection.
PAGE 12