Owner's Manual

RR2160 MkII Owner’s Manual
Outlaw Audio RR2160
MkII Stereo RetroReceiver
7
RR2160 MkII Front Panel
F1 Tone Off (Defeat) Control (Page 23)
Press to take the tone controls out of the signal
path so that they have no effect regardless of
where they’re set. The button’s blue LED will light
when tone controls are inactive.
F2 Bass Control (Page 23)
Turn to change the amount of low frequency
information being sent to your speakers or
headphones. This control is inactive when the
Tone Off button (F1) is active.
NOTE: When using small speakers (those with
limited bass handling capability) be careful when
increasi
ng bass content, particularly if any
Speaker EQ (F15) settings are active.
F3 Balance Control (Page 24)
Turn to adjust for left-right imbalances.
F4 Front Panel Display
This display shows the selected input or radio
station currently tuned, the current volume, and
menu items when operating or setting up your
RR2160
MkII.
F5 Treble Control (Page 23)
Turn to change the amount of high frequency
information being sent to your speakers or
headphones. This control is inactive when the
Tone Off button (F1) is a
ctive.
F6 Tuning Up (Menu Select) (Pages 25, 28)
F7 Tuning Down (Menu Select) (Pages 25, 28)
Press to tune to a broadcast frequency higher or
lower than the one currently selected. Also use
this button with the Menu and Enter buttons (F8
and F9) to navigate menus.
F8 Menu (Pages 27, 28)
Hold down this button (2-3 seconds) to access
and navigate the RR2160
MkII’s setup menu. Briefly
press this button to move back in menus or to
navigate available selections for Internet Radio.
F9 Enter (Pag
es 27, 28)
When navigating a menu (F8), this button will
access sub-menus or select highlighted options.
F10 On/Standby (Page 22)
When the RR2160
MkII is plugged in and the Master
Power switch (R11) is On, pressing the front
panel On/Standby button will toggle the unit from
standby condition (everything off except for the
IR sensor and associated circuitry) to fully
operational. When the unit is in standby mode,
the button’s blue LED will light.
F11 Headphone Jack (Page 24)
Connec
t a 1/4 inch phone plug (or an adaptor)
here for headphone listening.
F12 Headphone Level Control (Page 24)
Turn to control headphone volume.
F13 Aux Input Jack (Pages 12, 22)
Use this stereo 3.5mm jack to plug in any
portable audio device with a headphone or line-
level output.
F14 Speaker Selector (Page 23)
When two pairs of speakers are connected to the
RR2160
MkII, this will let you select which pair is
active.
F15 Speaker EQ (Page 23)
Press to cycle through the available Speaker EQ
settings.
STANDBY PHONES LEVEL AUX SPEAKER SPEAKER EQ
EXTERNAL
LOOP
USB
TONE OFF BASS BALANCE TREBLE
SOURCE
RECORD
VOLUME
MENU
ENTER
RR2160
MUTE
Mk
II
F1
F2 F3
F5
F4 F6 & F7
F19
F8
F9
F10
F11 F12
F13
F14 F15
F16
F17
F18 F20
F21