Instructions / Assembly

p. 6
INSTALLATION INSTRUCTIONS
Uninstall the 2 caps and 2 screws from the toilet seat.
4
Flip the seat cover gently and rest it onto the toilet bowl. Take care of not
pulling the connected wires.
The seat cover has a clip, holding it in place on the ceramic base. To
release the seat cover, rmly push the 2 plastic side panels near the top
with your ngers and pull up the seat cover.
5 6
PUSH
Position correctly the two xing bolts of the oor ange.
3
Install the oor ange according to the manufacturer’s
recommendations. Ensure that the ange is ush with the oor.
If the ange is not ush with the oor, this may result in an
inadequate installation.
Ensure that your water inlet pipe and your oor discharge drain are
installed according to the drawing. These are minimum measurements,
the toilet can be installed if your actual measurements are longer than
shown.
TIP: Align 2 pieces of masking tape with the center of the drain,
this will help you position the toilet in future steps.
1 2
150mm
400mm
305mm
NOT
SUPPLIED