User's Manual

3.Installation/Un-installation
AirLive Air3GII User’s Manual
51
In brief, SNMP, the Simple Network Management Protocol, is a protocol designed to give a
user the capability to remotely manage a computer network by polling and setting terminal
values and monitoring network events.
3.4.4 SNMP
1. Enable SNMP: You must check “Local”, “Remote” or both to enable SNMP function. If
te” is checked,
P 3, IP 4: Enter the IP addresses of your SNMP Management PCs. User has
“Local” is checked, this device will response request from LAN. If “Remo
this device will response request from WAN.
2. Get Community: The community of GetRequest that this device will respond.
3. Set Community: The community of SetRequest that this device will accept.
4. IP 1, IP 2, I
to configure to where this device should send SNMP Trap message.
5. SNMP Version: Select proper SNMP Version that your SNMP Management software
supports.