User's Manual

1. Introduction
5 AirLive AIR3G User’s Manual
1.4.4 WDS Bridge Mode
This mode is best used when you want to connect LAN networks together wirelessly (for
example, between office and warehouse). WDS Bridge using WPA-PSK or WPA2-PSK
encryptions might be limited to devices using the same wireless chipset.
WDS Bridge works by entering remote Bridge’s wireless MAC address on the WDS table.
You can find the MAC address on the bottom label of the Air3G.
1.4.5 WDS Repeater Mode
The purpose of repeater is to extend the wireless signal of the remote AP/Router. In Air3G,
the AP mode and the 3G Router mode also turn ito “WDS Repeater mode.” You can find the
WDS settings in the “Wireless Settings” page.
Both sides must support WDS connection
to work.
WDS Repeater in 3G Router Mode
The WDS Repeater function in 3G Router mode is to allow the remote AP to extend the
wireless signal of Air3G. Please see the diagram below: