User's Manual
Table Of Contents
- 1. Introduction
- 2. Installing the AirMax2
- 3. Configuring the AirMax2
- 4. Wireless Settings
- 5. Wireless Menu: Router Mode Settings
- 6. System Configurations
- 7. Device Status Menu
- 8. Bandwidth Control
- 9. Command Line Interface
- 10. Emergency Firmware Recovery
- 11. Frequent Asked Questions
- 12. Specifications
- 13. Wireless Network Glossary
2. Install the AirMax2
15 AirLive AIRMAX2 User’s Manual
Pole Mount Installation using WMK-AIRMAX
1. Unscrew the metal ring(pipe fastener) until one end of the ring come off completely
2. Put the metal ring through the holes on the bracket and wrap it around the pole.
3. Tighten the screw on the ring until the ring is very tight around the pole.
4. Now, install the AirMax 5 into the metal bracket and tighten the screws on the bracket
5. By adjusting the bracket screws, you can adjust the tilting angle of the AirMax2
Bracket Screw
1
2
4
3
5