User's Manual

4. Wireless Settings
AirLive AIRMAX2 User’s Manual
38
4.2.10 Client Isolation
Wireless Settings -> Client Isolation
The default setting is “Disable”. When enabled, the wireless clients will not be able to
communicate with each other. This feature is useful for public WiFi, WISP operators, and
Hotspot operators.
4.2.11 Data Rate
Wireless Settings -> Data Rate
Data Rate is the physical speed of transmission. The default setting is Auto. In “Auto”
mode, the data rate will adjust according to the connection condition. It is advised to put
the data rate in Auto.
However, you can also force the radio to operate at specific data rate. The highest for
11g/b and 11g Radio mode is 54Mbps.
4.2.12 Tx Output Power
Wireless Settings -> Tx Output Power
You can adjust the transmit output power of the AirMax2’s radio. The higher the output
power, the more distance AirMax2 can deliver. However, it is advised that you use just
enough output power so it will not create excessive interference for the environment. Also,
using too much power at close distance can create serious performance drop due to signal
distortion.
If you are not getting good signal, you can try to increase the output power. However; if
your signal appear to be strong but the performance is low., it is advised to reduce the
output power.
Please make sure not to exceed the legal limit of output power in your country. For EU, it
is limited to 20dBm. For U.S.A., the limit is 23dBm.