User's Manual
Table Of Contents
- 1. Introduction
- 2. Installing the AirMax2
- 3. Configuring the AirMax2
- 4. Wireless Settings
- 5. Wireless Menu: Router Mode Settings
- 6. System Configurations
- 7. Device Status Menu
- 8. Bandwidth Control
- 9. Command Line Interface
- 10. Emergency Firmware Recovery
- 11. Frequent Asked Questions
- 12. Specifications
- 13. Wireless Network Glossary
6. System Configurations
AirLive AIRMAX2 User’s Manual
54
6.2.1 DHCP Settings
DHCP Service: You can enable or disable DHCP server here.
z Disable: Disable DHCP server
z Client: The LAN interface will get IP address from DHCP server
z Server(default); The AIRMAX2 will act as DHCP server to provide IP
addresses to the clients on the LAN/Wireless interface. By default, the
DHCP server is on.
z DCHP Relay Agent: This function should be chosen in Universal
Repeater mode in order to assign IP address from remote DHCP server.
DHCP Client Range: You can define the IP pool from which the DHCP clients can
get IP address.. Click on “Show Clients” to see the current DHCP client table.
DHCP Release Time: You can define how long the AIRMAX2 will reserve IP
address for a particular PC or Device here.
6.2.2 Clone MAC Address
You can change the MAC address of your LAN port to other value here.
6.2.3 Disable PING
If you do not wish the AIRMAX2 to respond to remote PING command, please disable
it here.
Device IP
Settings
DHCP
Settings