User's Manual
Table Of Contents
- 1. Introduction
- 2. Installing the AirMax2
- 3. Configuring the AirMax2
- 4. Wireless Settings
- 5. Wireless Menu: Router Mode Settings
- 6. System Configurations
- 7. Device Status Menu
- 8. Bandwidth Control
- 9. Command Line Interface
- 10. Emergency Firmware Recovery
- 11. Frequent Asked Questions
- 12. Specifications
- 13. Wireless Network Glossary
6. System Configurations
57 AirLive AIRMAX2 User’s Manual
Public Key Upload: You can upload your public for the SSH authentication here.
6.6 Watchdog
System Configuration -> Watchdog
The Ping Watchdog will ping remote IP addresses to make sure the wireless connection is
active, if not, it can either reconnect or reboot. To prevent the AP from power recycling,
the PING watchdog will start 10 minutes after power up to prevent power recycle problem.
Watch Interval: means: "How often the CPE will PING". For example, it will PING
once every "1" minute.
Watch Host: This is the IP address for which the Watchdog will ping.
6.7 Firmware Upgrade
System Configuration -> Firmware Upgrade
You can upgrade the firmware of your AIRMAX2 (the software that controls your
AIRMAX2’s operation). Normally, this is done when a new version of firmware offers new
features that you want, or solves problems that you have encountered with the current
version.