User's Manual
Table Of Contents
- 1. Introduction
- 2. Installing the AirMax2
- 3. Configuring the AirMax2
- 4. Wireless Settings
- 5. Wireless Menu: Router Mode Settings
- 6. System Configurations
- 7. Device Status Menu
- 8. Bandwidth Control
- 9. Command Line Interface
- 10. Emergency Firmware Recovery
- 11. Frequent Asked Questions
- 12. Specifications
- 13. Wireless Network Glossary
11. Frequent Asked Questions
83 AirLive AIRMAX2 User’s Manual
Please also make sure the antenna (Operation Mode->Setup->Advance
Settings) is not set to use external antenna.
====================================================================
Question: Where is the signal survey function that displays the Signal Strength value
continuously?
Answer: The “Signal Survey” function is inside the Site Survey function. You can
access from “Wireless Settings -> Site Survey” menu.
====================================================================
Question: When I use “Site Survey”, why does the Signal LED goes off?
Answer: When you click on the Site Survey, the AirMax2 thinks you are trying to
choose a new network to associate. Therefore, it will disconnect from
current connection and wait until you establish a new connection.
====================================================================