User's Manual

3. Installation

AirLive N.Plug User’s Manual

Configure one N.Plug as Repeater without WPS

1. Set N.Plug in “Repeater mode” by using the hardware switch at the top of N.Plug.

2. Plug-in N.Plug at the electrical outlet and wait about 2 minutes for devices to complete

boot up.

3. Access WEB UI of N.Plug by enter http://192.168.1.253 in the URL box of Web

Browser (IE/Firefox/Safari)

4. Enter UserID/Password as admin/airlive

5. After Logged in, click at Wizard at top panel of the page.

6. Click at the Site survey button

7. Choose the SSID of your Router/AP device, and press OK.

8. Press Next Button

9. Select corresponded Encryption of your Router/AP device

10. Select the Pre-Shared Key format of your Router/AP device

11. Enter Pre-Share Key

12. Press Finish and wait for N.Plug to reboot

13. Wait for 2 minutes for the connection to establish between N.Plug and the Router/AP.

3.2 Login

Step1. Make sure the connection between your computer and Wireless Router setup

successfully.

Step2. Start your Web Browser.

Step3. In the Address box, enter the IP address of the Wireless Router, as in this example,

which uses the Wireless Router's default IP address: http://192.168.1.253.