User's Manual

4. Web Configuration
AirLive N.Plug User’s Manual
59
Enable Dynamic
Route
Dynamic routing performs the same function as static routing
except it is steadier. Dynamic routing allows routing tables in
routers to change as the possible routes change. There are
several protocols used to support dynamic routing including RIP
and OSPF.
NAT Network Address Translation (NAT) selects to enable or disable
this function.
Transmit Select to enable or disable RIP protocol for transmit.
Receive Select to enable or disable RIP protocol for receive.
Enable Static Route If you connect several routers with this Wireless Router, you
may need to set up a predefined routing rule to have more
effective network topology/traffic, this is called static route
between those routers and the Wireless Router.
To set static routers, enter the settings including route IP address,
route mask, route gateway and the route Interface from LAN or
WAN.
IP Address Set up the IP address that would like to send the packets pass
through.
Subnet Mask Set up the Subnet Mask that would like to send the packets pass
through.
Gateway Set up the gateway that would like to send the packets pass
through.
Metric It is used by a router to make routing decisions.
The metrics used by a router to make routing decisions. It is
typically one of many fields in a routing table. Router metrics can
contain any number of values that help the router determine the
best route among multiple routes to a destination. A router metric
typically based on information like path length, bandwidth, load,
hop count, path cost, delay, Maximum Transmission Unit (MTU),
reliability and communications cost.
Interface Select the interface of the setting path.