User's Manual

3. Configuring the N.Power
13 AirLive N.Power User’s Manual
The N.Power offers web browser (http) as management interface.
In this chapter, we will
explain N.Power’s management interface and how to get into them.
3.1 Important Information
The following information will help you to get start quickly. However, we recommend you
to read through the entire manual before you start. Please note the password and SSID
are case sensitive.
 The default IP address is: 192.168.1.254 Subnet Mask: 255.255.255.0
 The default Account is “admin”
 The default Password is “airlive”
 The default SSID is “airlive”
 The default wireless mode is : Router mode
 Please remember to “Apply Change” for settings to be saved and take effect.
 Please remember to “Reboot” the device after all settings are changed.
 The Emergency Firmware Recovery only works when you connect to LAN1~4
 By Default, the DHCP server is turned on in Router mode. The other modes’
DHCP servers are turned off. Therefore, if you switch from Router mode to other
modes, please remember to configure your PC’s IP address manually.
 For instruction on how to configure the FTP function, please go to
Chapter 4.3.
3.2 Prepare your PC
The N.Power can be managed remotely by a PC through either the wired or wireless
network. The default IP address of the N.Power is 192.168.1.254 with a subnet mask of
255.255.255.0. This means the IP address of the PC should be in the range of
192.168.1.1` to 192.168.1.253.
To prepare your PC for management with the N.Power, please do the following:
1. Connect your PC directly to the LAN port on the DC Injector of N.Power
3
3. Configuring the
N.Power