User's Manual

35
− Computation of measurement based on the 25 images acquired during the previous step
− Wait sequence if there is enough time before the acquisition of the next data point (depends on data
point acquisition frequency)
− Flush sequence to avoid clogging
The following drawing describes a typical sequence of operations:
The actual sequence of operations may differ depending on your cell line, for example with different
sedimentation times.
Pump Operations
You must pause your monitoring to get access to the pump menu
Backup pumping refers to pumping mode when not in an active monitoring session
Stop Pumping
One can stop the pump on purpose by selecting the stop pumping menu item. In that case the system will stop
pumping for 10 minutes and automatically resume afterwards.