User's Manual

58
Does it prevent from starting a monitoring?
YES
Does it interrupt the monitoring?
NO
Is it handled by OsOne?
YES. OsOne will automatically try to find cells 5 minutes later by performing a long range autofocus. (this
operation is repeated until cells are detected)
How to fix it?
If cells are clearly visible on the Live image but OsOne keeps making the autofocus in order to find cells:
• Press the “Pause monitoring” button.
• Activate the “Start monitoring with manual focus” in the monitoring configuration screen.
• Set the focus manually
• Start the monitoring
If no cells are visible :
• check if tubing is not clamped
• check if tubing did pop open after welding
• check if tubings are properly welded
How to prevent it?
By starting a monitoring session when cells are visible on the Live image.