Instructions / Assembly

Installation Instructions

SOLSERENE 36” CIRCLE

ACOUSTICAL PANEL

PARTS LIST:

• Two (2) panels

• Six (6) Angled Impaling Clips (use three [3] per panel)

• Twelve (12) anchor screws

CDC CORPORATION

800 Gustafson Road

Ladysmith, Wisconsin 54848

1-800-932-2383

www.occommercial.com

LEED is a registered trademark of U.S. Green Building Council.

TOOL LIST:

• #2 Phillips screwdriver

• Level

• Painters tape (optional)

• 3/16” carbide tipped drill bit (for pre-drilling concrete,

block, brick, or plaster)

CAUTION:

Clean, cut-resistant gloves should be worn as Angled Impaling Clips and anchor screws have sharp points.

MOUNTING:

1. Determine the placement of the panel on the wall.

A. Tip: use painters tape to mark the wall.

2. Attach recommended number of Angled Impaling Clips to wall, ensuring that they are at least three (3) inches away from

all edges of panel.

A. Keep Angled Impaling Clips level to ensure the panel will engage all Angled Impaling Clips evenly.

3. Position panel 5/8” above nal placement position and lightly touching the points of the Angled Impaling Clips.

4. With your hands placed at on panel face, rmly push the panel down and toward the wall until it is rmly

seated on the Angled Impaling Clips.

A. Position a wooden block on edge of panel and use a hammer to lightly tap for ne adjustment. If panel has to be adjusted

up, remove and re-seat panel on clips, do not tap upwards.

5. Inspect the edges of the panel where it meets the wall. The gap should be consistent around the entire perimeter of the panel.