FAQ

SAFE USE INSTRUCTION SHEET
Creation
Date
05-Mar-1997
Revision Date 29-Jun-2020 Version 2
0. General Information
This Safe Use Instruction Sheet is the document provided by Owens Corning to communicate recommended safe handling and
use instructions for manufactured articles neither regulated by OSHA Hazard Communication Standard, 29 CFR 1910.1200 nor by
the Canada Hazardous Products Regulation SOR/2015-17 (WHMIS 2015)
1. PRODUCT AND COMPANY IDENTIFICATION
Product Name
FOAMULAR® Extruded Polystyrene Insulation - Zero Ozone Depletion Formula
Synonyms
Foamular® 150, Foamular® 250, Foamular® 350, Foamular® 400, Foamular® 404,
Foamular® 600, Foamular® 604, Foamular® 1000, Foamular® C-200, Foamular® C-300,
Foamular® CodeBord®, Foamular® Cel-Lok®, Foamular® CW25, Foamular® High-R CW
Plus, Foamular® LT30, Foamular® LT40, Foamular® 404RB, Foamular® 604RB,
Foamular® AgTek, Foamular® PROPINK® Insulation Sheathing, Foamular® PINKCORE®,
Foamular® PINKCORE® TT, Foamular® Half-Inch, Foamular® INSULPINK®, Foamular®
INSULPINK® - Z, Foamular® THERMAPINK® 25, Foamular® Extruded Polystyrene,
Foamular® Insulating Sheathing, Foamular® INSUL-DRAIN®, Fabrication Billet,
Foamular® Ci-C, Foamular® Griboard, Foamular® CW25 Foam Sealed, Foamular®
High-R CW Plus Foam Sealed, Foamular® Project Panels, Foamular® GEO,
FOAMULAR® Cel-Drain®
Document code
OCFI00001
Recommended Use
Air and Water Sealing Insulation
Company Phone Number
1-800-GET-PINK or 1-800-438-7465
24 Hour Emergency Phone Number
Chemtrec 1-800-424-9300 or 1-703-741-5970 CCN17393
Emergency Telephone
1-419-248-5330 (after 5 pm ET and weekends)
E-mail address
safetydatasheet@owenscorning.com
Company Website
http://owenscorning.com/
2. HAZARDS IDENTIFICATION
Regulatory Status
This product is considered an article. 29 CFR 1910.1200(c) definition of an article is as
follows: "Article" means a manufactured item other than a fluid or particle: (i) which is
formed to a specific shape or design during manufacture; (ii) which has end use function(s)
dependent in whole or in part upon its shape or design during end use; and (iii) which under
normal conditions of use does not release more than very small quantities, e.g., minute or
trace amounts of a hazardous chemical (as determined under paragraph (d) of this section),
and does not pose a physical hazard or health risk to employees
This product is considered an article per the Canadian Hazardous Products Regulation
SOR/2015-17
Manufacturer Address
_____________________________________________________________________________________________
Page 1 / 4
Owens Corning Foam Insulation, LLC
One Owens Corning Parkway
Toledo, Ohio 43659

Summary of content (4 pages)