Devonshire™ Shingles Installation Instructions Instrucciones Para La Instalación De Tejas Devonshire™
Application Instructions Instrucciones para la colocación Before installing this product, check local building codes for their roofing requirements. These shingles are designed for new or reroofing work over any properly built and supported wood roof deck having adequate nail holding capacity and a smooth surface. Check local building codes. Antes de colocar este producto, verifique los códigos locales de construcción con el fin de saber cuáles son los requisitos para su techo.
1. Specialty Eave Flashing: Where required by code. WeatherLock® underlayment or equivalent eave and flashing membrane applied to a point at least 24" beyond interior wall line. See manufacturers installation instructions. See Fig. 1. 1. Tapajuntas especial para aleros: Donde lo requiera el código. Revestimiento WeatherLock®, o impermeabilizante equivalente para aleros y tapajuntas instalada hasta un punto de al menos 24 pulg. pasando la línea de la pared interior.
. Chalk Lines: When laying out the application of Owens Corning™ Devonshire™ shingles, vertical chalk lines must be snapped. These chalk lines will be spaced as follows: From the rake edge, measure 15 1/2 inches and snap a chalk line. From the rake edge again, measure 27 1/2 inches and snap a second chalk line, and once more from the rake edge, measure 39 1/2 inches and snap a third and final chalk line. This will be the layout for installing the shingles offset pattern. See Fig. 4. 4.
6. Colocación de tejas: Hilera inicial Nota: Se debe cortar la hilera inicial de la teja Owens Corning™ Devonshire.™ Para ayudar en la colocación de estas tejas, se recomienda que se usen líneas de tiza horizontales. Desde la hilera inicial, mida 7 1/8 pulgadas desde los bordes del alero y dibuje una línea de tiza. Y para la primera línea de tejas, mida 12 3/4 pulgadas desde los bordes del alero y dibuje una segunda marca de tiza. No se permite la aplicación vertical.
C. Third Course: Remove 24" from the left end of the shingle. Align the right edge of the shingle with the 15 1/2" vertical chalk line and the right alignment notch on the second course. Align the bottom edge of the shingle with the top of the shingle cutouts in the second course leaving 5 5/8" exposure. This will leave 1/2" overhang at the rake. Complete the course with full shingles. See Fig. 6C. Fasten securely according to fastening instructions. See Fig. 5. 6D.
. Valley Construction: Closed-Cut Valley See Fig. 7. A closed-cut valley can be used as an alternative to an open valley and is applied as follows: Lay a 36" wide valley liner of self-adhered membrane underlayment or equivalent. A 36" wide minimum 50 lb. smooth surface roll roofing can also be used as a valley liner. Lay all shingles on one side of valley and across center line of valley a minimum of 12". Fasten a minimum of 6" away from center line on each side of valley.
OWENS CORNING ROOFING AND ASPHALT, LLC ONE OWENS CORNING PARKWAY TOLEDO, OHIO, USA 43659 1- 800 - GET- PINK® www.owenscorning.com/roofing Pub. No. 10018875. Printed in U.S.A. February 2014. THE PINK PANTHER™ & © 1964–2014 Metro-Goldwyn-Mayer Studios Inc. All Rights Reserved. The color PINK is a registered trademark of Owens Corning. © 2014 Owens Corning. All Rights Reserved.