Woodcrest® & Woodmoor® Shingles Installation Instructions Instrucciones Para La Instalación De Tejas Woodcrest® Y Woodmoor® ® WOODCREST & WOODMOOR SHINGLES ®
Application Instructions: Instrucciones para la aplicación: Before installing this product, check local building codes for their roofing requirements. Antes de instalar este producto, consulte los códigos de construcción locales para informarse sobre los requisitos de techado. These laminated shingles are designed for new or reroofing work over any properly built and supported wood roof deck having adequate nail holding capacity and a smooth surface.
1 2 Specialty Eave Flashing: ® WeatherLock underlayment or equivalent eave and flashing membrane applied to a point at least 24" beyond interior wall line. See manufacturer’s installation instructions. See Fig. 1. Underlayment: Standard Slope (4" in 12" or more): Application of underlayment, metal drip edges, and eaves flashing: See Fig. 2. Low Slope (2" in 12" to less than 4" in 12"): Application of underlayment and metal drip edges: See Fig. 2A.
3 Starter Course: Left Rake Application: Cut 35" off from the first bottom starter piece. Fasten the remaining 5" x 133⁄ 8" to the deck as shown in Fig. 3, followed by a full 133⁄ 8" x 40" starter piece to the deck with 5 fasteners as shown. Right Rake Application: Cut 5" off from the first bottom starter piece. Fasten the remaining 35" x 133⁄ 8" to the deck as shown in Fig. 3, followed by a full 133⁄ 8" x 40" starter piece to the deck with 5 fasteners as shown. Fig.
5 Mansard or Steep Slope Fastening Pattern: Mansard or Steep Slope Fastening Pattern Esquema de fijación para mansardas o pendientes agudas Fig. 5 See Fig. 5.
8 Fig. 8 5" & 15" Course Application: Owens Corning™ Woodcrest®/ Woodmoor® shingles can be applied with a 5" & 5" OR 5" & 15" offset, (See Fig. 4) with 4" exposure. Shingles can be installed from either left or right rake edge. Shingle Application 5" & 15" offset pattern Aplicación de tejas en patrón de desplazamiento de 5 pulg. y 15 pulg. First course Primera hilera rse cou 1 1st ilera40" H First Course: Start with a full shingle even with the lower edge of the starter course shingle. See Fig. 8.
9 Valley Construction: Open Valley ™ Lay a 36" wide valley liner of Owens Corning WeatherLock® underlayment or equivalent. A 36" wide minimum 50-lb. smooth surface roll roofing can also be used as a valley liner. Fasten on outer edges only a minimum of 6" away from centerline on each side of valley. See Fig. 9. Recommended valley flashing is 24" wide 26-gauge galvanized metal or an equivalent corrosion-resistant, nonstaining material.
Closed-Cut Valley See Fig. 9B. A closed-cut valley can be used as an alternative and is applied as follows: Lay a 36" wide valley liner of Owens Corning™ WeatherLock® underlayment or equivalent. A 36" wide minimum 50-lb. smooth surface roll roofing can also be used as a valley liner. Lay all shingles on one side of valley and across centerline of valley a minimum of 12". Fasten a minimum of 6" away from centerline on each side of valley. Strike a chalk line 2" from the centerline of the unshingled side.
Fig. 10 Step Flashing: Use 5" x 6" corrosion-resistant metal where roof planes butt against vertical sidewalls or chimneys. See Fig. 10. Step Flashing Revestimiento escalonado Metal flashing 5" x 6" Revestimiento metálico de 5 pulg. x 6 pulg. 2" top lap Superposición superior de 2 pulg. Nail flashing to roof Clavar revestimiento al techo 6" 10 Revestimiento escalonado: Utilice metal resistente a la corrosión de 5 pulg. x 6 pulg.
For additional information on Owens Corning™ Exterior Systems or Insulation Systems, visit our Web site at www.owenscorning.com or call 1-800-GET-PINK®. OWENS CORNING ROOFING AND ASPHALT, LLC ONE OWENS CORNING PARKWAY TOLEDO, OHIO, USA 43659 1- 800 - GET- PINK® www.roofing.owenscorning.com Pub. No. 59547-E. Printed in U.S.A. January 2010. THE PINK PANTHER™ & ©1964 –2010 Metro-Goldwyn-Mayer Studios Inc. All Rights Reserved. The color PINK is a registered trademark of Owens Corning. ©2010 Owens Corning.