Installation Guide

Product Data Sheet
EcoTouch
PINK
®
FIBERGLAS
Insulation
with PureFiber
®
Technolog y
Applicable Standards
EcoTouch
Unfaced Insulation is
manufactured in compliance with
ASTM Standard Speci cation C
665 and is classi ed
noncombustible per ASTM E 136.
EcoTouch
Kraft-faced Insulation is
manufactured in compliance with
ASTM C 665, Type II, Class C.
EcoTouch
Foil-faced Insulation is
manufactured in compliance with
ASTM C 665, Type III, Class B
and C. Federal Speci cation
HH-I-521F has been canceled and
is replaced by ASTM C 665.
The thermal resistance values for
EcoTouch
Insulation were tested
in accordance with ASTM C 518;
R-value for insulation only.
The surface burning characteristics
of EcoTouch
Insulation were
derived from products tested in
accordance with ASTM E 84. This
standard is used solely to measure
and describe properties of
products in response to heat and
ame under controlled laboratory
conditions, and should not be used
to describe or approve the  re
hazard of materials under actual
re conditions. However, the
results of these tests may be used
as elements of a  re risk
assessment that takes into account
all of the factors pertinent to an
assessment of the  re hazard of a
particular end use. Values are
reported to the nearest  ve rating.
The vapor retarder permeance of
the kraft and foil facings on
EcoTouch
Insulation were
developed from tests conducted
in accordance with ASTM E 96,
desiccant method.
Notes
1. As manufactured, FIBERGLAS™ insulation is
resistant to mold growth. However, mold growth
can occur on building materials, including insulation,
when it becomes contaminated with organic material
and when water is present. To avoid mold growth on
FIBERGLAS™ insulation, remove any water that has
accumulated and correct or repair the source of the
water as soon as possible. Insulation that has become
wet should be inspected for evidence of residual
moisture and contamination, and any insulation that
is contaminated should be promptly removed and
replaced.
2. According to 2010 clinical trial conducted in Toronto,
Canada by Ducker Worldwide on behalf of Owens
Corning Insulation Systems, LLC.
3. Unfaced insulation is made with a minimum of 99
percent by weight natural materials consisting of
minerals and plant-based compounds.
4. Certi ed by Scienti c Certi cations Systems to have
a minimum of 50% recycled glass content, with at
least 30% post-consumer recycled and the balance of
pre-consumer recycled glass content.
5. Owens Corning
EcoTouch
Unfaced FIBERGLAS
insulation is veri ed to be formaldehyde free by the
GREENGUARD Environmental Institute.
OWENS CORNING INSULATING SYSTEMS, LLC
ONE OWENS CORNING PARKWAY
TOLEDO, OHIO, USA 43659
1
-
800
-
GET
-
PINK
®
www.owenscorning.com
Pub. No. 10013811-B. Printed in U.S.A. March 2011. THE PINK
PANTHER
& ©19642011 Metro-Goldwyn-Mayer Studios Inc. All Rights
Reserved. The color PINK is a registered trademark of Owens Corning.
©2011 Owens Corning.
Disclaimer of Liability
Technical information contained herein is furnished
without charge or obligation and is given and accepted
at recipient’s sole risk. Because conditions of use may
vary and are beyond our control, Owens Corning makes
no representation about, and is not responsible or
liable for the accuracy or reliability of data associated
with particular uses of any product described herein.
Nothing contained in this bulletin shall be considered a
recommendation.
The GREENGUARD INDOOR AIR QUALITY
CERTIFIED mark is a registered certi cation mark
used under license through the GREENGUARD
Environmental Institute.
Formaldehyde
FREE
GREENGUARD Indoor Air Quality and GREENGUARD Children & Schools
SM
applies to EcoTouch™ Unfaced Batts, EcoTouch™ Faced Batts and Unbonded
Loosefi ll insulation. GREENGUARD Formaldehyde Free applies to EcoTouch™
Unfaced Batts and unbonded loose ll insulation.
GREENGUARD Children & Schools
SM
applies to Flame Spread 25 FSK Faced;
Flame Spread 25 Extended Flanges PSK Faced; Sound At tenuation Batt
Insulation; Sonobatts
®
Insulation Unfaced; Sonobatts
®
Insulatioin Kraft-Faced
and Metal building insulation.
SCS 50% recycled content applies to
EcoTouch™ Unfaced Batts and Rolls,
EcoTouch™ Faced Batts and Rolls,
Loosefi ll insulation, Metal building
insulation products and fl exable Air
handling products.
Applies to EcoTouch™ Unfaced Insulation