Dimensions Guide
ECOTOUCH
®
PINK
®
FIBERGLAS
™
INSULATION
™
Data Sheet | EcoTouch
®
Pink
®
Fiberglas
™
Insulation | August 2019
Description
Owens Corning
®
EcoTouch
®
PINK
®
Fiberglas
™
Insulation
with PureFiber
®
Technology is a preformed, exible blanket
insulation. It is produced in R-values from 11 to 49, with
thicknesses ranging from 31/2 inches to 14 inches. It is
available unfaced, or faced with either a kraft or foil vapor
retarder.
Features
• Excellent thermal control
• Effective acoustical control
• Long term performance and will not settle nor
slump within wall cavities
• With less dust than other berglass products,
EcoTouch
®
PINK
®
Fiberglas
™
insulation has excellent
stiffness and recovery characteristics
1
• Compression packaging from Owens Corning
speeds job site handling and installation
1. According to 2010 clinical trial conducted in Toronto, Canada by Ducker
Worldwide on behalf of Owens Corning Insulation Systems, LLC.
Applications
• Wood-framed wall, oor and roof/ceiling cavity wall
assemblies
• Metal-framed wall and oor cavity wall assemblies
• Furring strips installed on the interior surface of
basement walls
• Interior surfaces of basement and unvented crawl
space foundation walls
Standards, Codes Compliance
• Manufactured in compliance with ASTM C 665
• Federal Specication HH-I-521F has been canceled and is replaced by
ASTM C 665
• Classied non-combustible when tested in accordance with ASTM E 136
• Unfaced EcoTouch
®
PINK
®
Fiberglas
™
insulation is acceptable for use in ICC
building construction types I through V; kraft and foil faced EcoTouch
®
PINK
®
Fiberglas
™
insulation are acceptable for use in ICC building construction
types III, IV and V
• Certied to meet California Code of Regulations, Title 24, Chapter 12-13,
Article 3, “Standards for Insulating Material”
Physical Properties
PROPERTY (UNIT) TEST VALUE
Thermal Resistance ASTM C518 See “Availability”
table for R-values
Surface Burning Characteristics
2
(ame spread / smoke developed)
Unfaced
Kraft faced
Foil faced
ASTM E 84 /
UL 723
25 / 50
NR / NR
75 / 150
Critical Radiant Flux (W/cm
2
) ASTM E970 >0.12
Water Vapor Permeance (perms)
Kraft faced
Foil faced
ASTM E96
1.0
0.5
Water Vapor Sorption
(by weight)
ASTM C1104 <5%
Odor Emission ASTM C1304 Pass
Corrosion Resistance ASTM C665,
part 13.8
Pass
Fungi Resistance ASTM C1338 Pass
2. The surface burning characteristics of EcoTouch
®
Insulation were derived from products tested
in accordance with ASTM E84. This standard is used solely to measure and describe properties
of products in response to heat and ame under controlled laboratory conditions, and should not
be used to describe or approve the re hazard of materials under actual re conditions. However,
the results of these tests may be used as elements of a re risk assessment that takes into
account all of the factors pertinent to an assessment of the re hazard of a particular end use.
Values are reported to the neare ve rating.