Download the Owlet App. Plug in and follow app instructions to pair the Cam with our Owlet Account.
Yau can set up the Cam in two ways: Place it on 8 flat surface using the magnetic has and adjust for desired tilt angle. Mount it on a wall above the brie using the base as a wall mount for a view of the crib or for an expanded view of your nursery, The next steps will guide you through mounting the Cam o the wall {above the crib}. \
1. Measure and mark Measure 36 inches from the top of your baby's mattress and make a mark on the will this is where the Cam will be mounted. Center this mark above baby's crib for the optimal viewing angle Consider which outlet to use. The cutlet should be ot least 36 Inches way from the orb to ensure no exposed cables will be within baby's 36 niches reach. The next steps will instruct (six cable guards) you on how to cover ail cables. cinches 2.
3. Unwind the cable Uncle the two clasps on the cable b and uric the cable from the cabs box, leaving the temperature sensor clipped in 4, Thread the cable Thread the cable down the channel of the mounding plate, aligning the range sticker on the cable to the top of the mounting plate.
5. Mount the base Position the large holes of the magnetic base over the protruding tabs on the mounting plate, then slide downward until it clicks, sticker &, Attach the Cam Attach the Cam to the magnetic base Plug the cable into the Cam Banks sure vou have sough cable slack to position the Cam bt your desired angle.
7. Mount cable guards 1 Peel off adhesive caver from the back of a long guard 2) Thread cable down the center of a long guard 3 Snap long guard onto the bottom of the mounting plate 4} Press firmly onto wall 53 Repeat steps 1-4 with remaining dong guards until you reach the height of the wall outlet Brackets 8. Mount L-bracket Lie the right or left L-bracket to guide the cable in the direction of the wall cutlet stall long guards until any celeb within 36 inches of the edge of the orb is covered.
. Mount the cable box Rag any excess cable not needed to reach the outlet inside the cable box Then, close e cable box using the tie clasps. Peel off adhesive cover and press the cable box firmly note the wall next to the end piece, you have questions about the Owlet Can, visit eur Help Center at support owletcare.
3. Dérouler le cible Détachez les deux fermoirs sur 1z botte de cible et déroulez e câble d'alimentation LB situé dans [a bolet de connexion et laisser l détecteur de température fixé 4.
& 7. Montez les productibles prosecteurs Sangs 1) Retirez 2 superficie protectrice de [adhésif situe & "arrière dun long garde-câble 2) Faufilez le cible dans le centre dun garde-meubles 3) Enclenchez e gang garde-câble sur e bes de fa pique de montage 4) Crassez fermement sur le mur 5} Répétez les étapes 1 3 4 avec tous les gongs garde-meubles jusqu'a atteindre la haveur de 2 prise murale &.