ZigBee Multi-Sensor Quick Start Guide 1
Safety Handling WARNING: Failure to follow these safety notices could result in fire, electric shock, other injuries, or damage to the ZigBee Multi-Sensor and other property. Read all the safety notices below before using the ZigBee Multi-Sensor. • Avoid high humidity or extreme temperatures. • Avoid long exposure to direct sunlight or strong ultraviolet light. • Do not drop or expose the unit to intense vibration. • Do not disassemble or try to repair the unit on your own.
Technical Specifications ZigBee Wireless Connectivity ZigBee Profile RF Characteristics Battery • 2.4GHz IEEE 802.15.4 • ZigBee 3.0 • Operating frequency: 2.
Detecting range(PIR) Dimensions Mounting Type • Distance: 5m • Angle: up/down 100° left/right 120° • 62(L) × 62 (W)× 15.5(H) mm • Line length of remote probe: External temperature: 2.
1 Welcome The Multi-sensor is used to measure the ambient temperature & humidity with built-in sensor and external temperature with remote probe. It is available to detect motion, vibration and allows you to receive notifications from mobile app. The above functions can be customized, please use this guide according to your customized functions. This guide will provide you with an overview of the product and help you get through the initial setup.
Features: • ZigBee 3.0 • PIR motion detection (Optional) • Vibration detection (Optional) • Environmental temperature & humidity measuring (Optional) • External temperature probe(Optional): Available for water measurement • Low power consumption 2 Installation You can mount the multi-sensor to the wall, ceiling or keep your multi-sensor on a bookshelf or table. • Please ensure that the surface is clean and secure. • You can peel off the tape on the back or lock it with screws.
1. Avoid mounting the Multi-sensor close to pets, air conditioners, heaters, sunshine or places where the temperature varies. 2. You need to pay attention to the distance and range of the sensor when installing. 100˚ 120˚ 2.
External temperature probe: Please refer to the mounting example below. You can measure the temperature by touching the probe with the measured object. Such as water, floor, metal etc.
3 Get to know your device LED indicator Reset button LED indicator The LED status gives the following information: LED status Red LED flashes once What it means Motion detected When you press the reset button once Flashing green Flashing red Device has joined a ZigBee network. Device has not joined a ZigBee network.
Reset button Reset: Press and hold the reset button for 10 seconds until the LED light flashes three times at third second, and it will flash for three times again at tenth second. 4 Configure Network 4.1 To get started, you will need: • A Zigbee Gateway. • A mobile phone with a mobile APP installed. 4.2 Adding to the gateway's network 1. Set your gateway to permit joining (see your gateway's manual). 2.
to factory defaults). 3. Make sure the Multi-sensor is in the range of gateway's network. After few seconds the Multi-sensor will join the gateway automatically and the LED indicator will flash green when it successfully joined. Note: If the adding is failed, simply reset the Multi-sensor and retry.