User Manual
Table Of Contents
- Table of Contents
- 1. General Safety Requirements
- 2. Safety Terms and Symbols
- 3. General Characteristics
- 4. Quick Start
- 5. Front Panel Operation
- To set channels
- To set signals
- To Generate the Modulated Waveform
- To Generate Sweep
- To Generate Burst
- To Save and Recall
- To Set the Utility Function
- To Use Built-in Help
- 6. Communication with PC
- 7. SCPI
- 8. Troubleshooting
- 9. Technical Specifications
- 10. Appendix
4.Quick Start
7
①
Power socket
AC input connector
②
Fuse
Use the specified fuse according to the voltage scale.
③
Power switch
Switch between 110 V and 220 V.
④
USB (type B)
connector
This can be used to connect a USB type B controller.
Connect with an external device, such as connected to a PC
and controlled via PC software.
⑤
Ext Mod In
Connector
External modulation input, use it as external signal source.
⑥
Ext Trig/Burst/Fsk
In connector
This signal can be used as external signal source in Sweep,
Burst and FSK mode.
⑦
Ref Clk/Counter In
connector
To accept an external clock signal, or to accept the input
signal of counter. (See page 38, To Set the Counter)
⑧
Ref Clk Out
connector
To synchronize generators. Output a clock signal generated
by the crystal inside the generator. (See page 38, To Set the
Clock Source)
User Interface
④
⑨
⑧
③
⑦
②
①
⑥
⑤
⑩
⑪
Figure 4-3 User interface (take Sine for instance)
①
Current channel
②
Parameter 1, display parameter and edit the focused parameter
③
Current signal type or mode
④
The setting menu of current signal or mode