User Manual
Table Of Contents
- Table of Contents
- 1. General Safety Requirements
- 2. Safety Terms and Symbols
- 3. General Characteristics
- 4. Quick Start
- 5. Front Panel Operation
- To set channels
- To set signals
- To Generate the Modulated Waveform
- To Generate Sweep
- To Generate Burst
- To Save and Recall
- To Set the Utility Function
- To Use Built-in Help
- 6. Communication with PC
- 7. SCPI
- 8. Troubleshooting
- 9. Technical Specifications
- 10. Appendix
5.Front Panel Operation
37
Pulse Width of Pulse 200 us
Duty Cycle of Pulse 20%
Modulation Default
Carrier 1 kHz Sine Wave
Modulating 100 Hz Sine Wave
AM Depth 100％
FM Deviation 100 Hz
PM Phase Deviation 0°
FSK Hop Frequency 100 Hz
FSK Frequency 100 Hz
Source Internal
Sweep Default
Start/Stop Frequency 100 Hz/1 kHz
Time 1 sec
Mode Linear
Burst Default
Frequency 1 kHz
Count 1 Cycle
Period 1 sec
Phase 0°
Others Default
Brightness
95%
Separator Comma
Screen Saver time 100 minutes
Load High Z
Phase Deviation 0°
Clock Source Internal
Channel Output Control Off