OPS305 Occupancy Sensor Quick Start Guide
Safety Handling WARNING: Failure to follow these safety notices could result in fire, electric shock, other injuries, or damage to the Occupancy Sensor and other property. Read all the safety notices below before using the Occupancy Sensor. • Avoid high humidity or extreme temperatures. • Avoid long exposure to direct sunlight or strong ultraviolet light. • Do not drop or expose the unit to intense vibration. • Do not disassemble or try to repair the unit on your own.
Technical Specifications Wireless Connectivity • 2.4GHz IEEE 802.15.4 ZigBee • ZigBee 3.0 ZigBee Profile RF Characteristics • Operating frequency: 2.4GHz • Range outdoor/indoor: 100m / 30m (Open area) Operating Voltage • Micro-USB Detector • 10.
1 Welcome OPS305 Occupancy Sensor can detect presence, even if you are asleep or in a stationary posture. Presence detected via radar technology, which is more sensitive and accurate than PIR detection. It can be tremendously beneficial in nursing homes to monitor and link with other devices to make your home smarter. This guide will provide you with an overview of the product and help you get through the initial setup to installation. Features: • ZigBee 3.
2 Get to know your device LED indicator Micro-USB Reset Button Reset Button Reset: Press and hold the reset button for 10 seconds until the LED light flashes three times at third second, and it will flash three times in the tenth second.
LED indicator The LED status gives the following information of the occupancy sensor: LED Status No light What it means Device has joined a ZigBee network. Continuous and slow Device has not joined a ZigBee network. flashing Flashing once Presence detected When you press the reset button once Flashing once Device has joined a ZigBee network. Flashing three times Device has not joined a ZigBee network. 3 Configure Network 3.1 Before starting, you will need: • A ZigBee Gateway. 3.
4 Installaion Important safety information! • Do not touch the terminals of the device while testing. • Turn off all the power supply for this equipment before installing. • Make sure that the power supply is off before connecting or disconnecting it to an auxiliary device. • Always use a properly rated voltage sensing device to confirm power is off. • Replace all devices, doors and covers before applying power to the equipment. 1.
2. You need to pay attention to the distance and range of the occupancy sensor when installing. Within the sensing range, avoid facing another occupancy sensor or radar equipment.
3. Use the mounting bracket as template to mark the two holes on the ceiling for installing screws. 4. Screw the mounting bracket onto the ceiling according to marked location. Install wall plugs if necessary. 5. Locate the hooks of the mounting bracket and line up the hooks with the mounting holes on occupancy sensor. Fit the hooks into the mounting holes as the picture below. Installation is now completed.
