User Manual

4.Panel Operation
7
4. Panel Operation
4.1 Turn On/Off the Channel Output
Press the On/Off key to turn on/off the channel;
4.2 Set the Output Voltage/Current
In the channel setting area, press the ∧ / ∨ keys to move the red cursor between parameters.
After selecting the output voltage/current setting value, turn the knob to change the current cursor
value, and press ＜ / ＞ key to move the cursor position.
Set values of voltage
Set values of current
4.3 Over Voltage/Current Protection
Overvoltage protection (O.V.P) or overcurrent protection (O.C.P): after the output is turned on,
once the output voltage/current reaches the set value of O.V.P/O.C.P, the instrument will cut off
the output, a warning will show on the screen.
Note:
When the instrument disables the output due to protection, after you make some
adjustments, the channel must be restarted to output normally.
This function can keep the power output from exceeding the load rating to protect the load.
In the channel setting area, press the ∧ / ∨ keys to move the red cursor between parameters.
After selecting the overvoltage/overcurrent protection value, turn the Knob to change the current
cursor value, and press the ＜ / ＞ direction key to move the cursor position.