Installation Guide
www.OZCOBuildingProducts.com
Hammered Dome Cap Nut Item #: 56622
OrnamentalHardware-InstallationGuide
Steps:
1. Remove threaded covers from all Dome Cap Nuts
2. Insert Lag Bolts into Cap Nut
3. OWT Lag Bolts require a 3/8” Hex Bit
4. Replace Threaded Covers do not over tighten
5. HINT: Use tread lock on Threaded Covers in accessible areas
Use and Care: This hardware may not be suitable for every situation or installation application. A design
professional should be consulted to ensure the specic installation application meets local building code
requirements.
If hardware becomes dirty clean with soap and water. Avoid abrasions to surface and touch up any scrapes
with paint. Rinse with fresh water if hardware comes in contact with ice salt or salt water.