Installation Guide
www.OZCOBuildingProducts.com
General Guidelines:
• Materials are heavy and bulky minimum of 2 people are required for most installations
• Brace and tie off large beams and posts until all connections are made
• Wear proper safety equipment
• Check with local authorities and home owners association before construction
• Check for underground and or hidden utilities that could be damaged
• Be sure to use the right tool for the job
• Plan ahead and have the required hardware, fasteners and tools close at hand before starting the
installation
Steps:
1. Measure along beam and make vertical ½” long vertical marks from top edge of beam
2. Position the Rafter Clip so that the bend is ush with top of the beam and the point of the diamond
shaped cut out is centered on the marks
3. Install screw into the beam
4. Repeat for all other rafter locations
5. Center the rafter on the beam and Rafter Clip
6. Install screw into rafter
Pro Technique: If the installation requires the brackets to be mounted on both sides of the same
board be sure to inspect the brackets to orientate the holes so the attachment hardware does not
collide. NOTE: The fastener holes are offset on each bracket.
Use and Care: This hardware may not be suitable for every situation or installation application. A
design professional should be consulted to ensure the specic installation application meets local
building code requirements.
If hardware becomes dirty clean with soap and water. Avoid abrasions to surface and touch up any
scrapes with paint. Rinse with fresh water if hardware comes in contact with ice salt or salt water.
• Attractive Sturdy Angle Bracket Can Be Used In A Wide Range Of Projects
• Decorative Bracket Cutout Makes Exact Location Easy To Establish
• Offset Hole Pattern For Unobstructed Back To Back Mounting
• Includes Hardware For Attaching 2” Rafters
• Galvanized & Power Coated 12 Ga. Steel
RafterClips2″ Item #: 56617
LaredoSunset-InstallationGuide