Install Instructions

HAZARDOUS VOLTAGE - DISCONNECT POWER BEFORE SERVICING
WARNING:
ALL phases of this installation must comply with NATIONAL, STATE AND LOCAL CODES
IMPORTANT - This Document is customer property and is to remain with this unit. Please return to service information pack
upon completion of work.
Installer’s Guide
BAYBACKSPACER
Supplementary Blanking Strip
18-CH103D1-1A-EN
GENERAL
This accessory kit offsets the furnace coil from the back of the
furnace ~1.5 inches, allowing clearance of the flue piping with
condensate and refrigerant lines in most applications. For
applications where 1.5 inches is not available, see alternative
kit BAYSPACER.
Offsetting the coil does not affect the performance of the
system.
The manufacturer recommends this kit when the furnace is ad-
joined to an evaporator coil with left side only condensate drain
openings or refrigerant line connections that may interfere with
flue gas or combustion air vent piping.
This accessory kit is used with the following furnace models:
J801 L8X1B070*
L8X1A055* L8X1C100*
s
WARNING
SAFETY HAZARD! This information is intended for
use by individuals possessing adequate backgrounds
of electrical and mechanical experience. Any
attempt to repair a central air conditioning product
may result in personal injury and/or property damage.
The manufacture or seller cannot be responsible for
the interpretation of this information, nor can it
assume any liability in connection with its use.
s
WARNING
HAZARDOUS VOLTAGE!
Disconnect all electrical power, including remote
disconnects before installing or servicing. Follow
proper lockout/tagout procedures to ensure the
power can not be inadvertently energized. Failure
to disconnect power before servicing could result in
death or serious injury.
SAFETY HAZARD!
Sharp Edge Hazard. Be careful of sharp edges on
equipment or any cuts made on sheet metal while
installing or servicing. Personal injury may result.
CAUTION
INSPECTION
Check carefully for any shipping damage. This must be re-
ported to and claims made against the transportation company
immediately. Any missing parts should be reported to your
supplier at once and replaced with authorized parts only.
KIT CONTENTS
Open and inspect contents for damage or missing items.
Each kit contains:
No. Qty. Part No. Description
1 1 18-CH103D1-1A-EN Installer's Guide
2 1 D346583P01 Adjustable Blank-off
3 8 D346588P01 Screw
2
1
3