J4HP4 Installation Manual

20
1/2”nut
5/16”nuts
STEP 4 - Remove fan motor by removing 5/16” nuts from cover.
STEP 5 - Remove fan blade from motor by removing 1/2” nut and
place fan on the ground.
STEP 6 - Reverse removal process to reinstall the fan and motor.
Note: When connecting motor wires be sure to check motor direction.
Damage will occur to condenser unit if you remove 5/16’’ nuts
prior to cover removal.
Figure 43
17. Wiring diagrams
17.1 For AC
C
S
R
FAN
ORANGE
BROWN
GREEN
BLACK
BLACK
BLACK
GREEN
A2
A1
L2
T2
L1
T1
BLACK
YELLOW
C
Y
LOW
WARNING: CABINET MUST BE PERMANMENTLY
GOUNDED AND ALL WIRING TO CONFORM TO
I.E.C,N.E.C,C.E.C,C.L.C,AND LOCAL CODES AS APPLICABLE
REPLACEMENT WIRE MUST BE THE SAME GAUGE AND
INSULATION TYPE AS ORIGINAL WIRE
LINE VOLTAGE
FACTORY STANDARD
FIELD INSTALLED
OPTIONALFACTORY
VOLTAGE
FACTORY STANDARD
FIELD INSTALLED
FACTORY OPTIONAL
USE COPPER CONDUCTORS ONLY
BLACK
OT TATSOMREHT
CC
COMP
HPS
YELLOW
BLACK
BLACK
POWER
L2
L1
GROUND
PLUG PLATE
RC 3
RC 1
RC 2
WHITE OR YELLOW
RED
BLACK
RED
CC COMPRESSOR CONTACTOR
RC 1 RUN CAPACITOR 1
RC 2 RUN CAPACITOR 2
RC 3 RUN CAPACITOR 3
COMP COMPRESSOR
HPS HIGH PRESSOR SWITCH
Figure 44