J801X Installation Manual

INSTALLATION CHECKLIST
INSTALLER NAME:
CITY: STATE:
INSTALLATION ADDRESS:
CITY: STATE:
UNIT MODEL #
UNIT SERIAL #
Minimum clearances as shown in
Figure 1, (page 5)?
YES NO
Has the owner’s information been
reviewed with the home-owner?
YES NO
Has the literature package been
left near the furnace?
YES NO
ELECTRICAL SYSTEM
Electrical connections tight? YES NO
Line voltage polarity correct? YES NO
Supply Voltage: ............................................................... VOLTS
Has the thermostat been calibrated? YES NO
Is the thermostat level? YES NO
Is the heat anticipator setting correct? YES NO
GAS SYSTEM
Gas Type: (circle one)
Natural
Gas
Propane
Gas pipe connections leak tested? YES NO
Gas Line Pressure: .......................................................... (in - W.C.)
Installation Altitude:............................................................(FT.)
Deration Percentage: ......................................................... (%)
Furnace Input:....................................................................(Btuh)
Supply Air Temperature: ................................................... (° F)
Return Air Temperature: ...................................................(° F)
Temperature Rise: ............................................................(° F)
COMBUSTION AIR & VENTING SYSTEM
Is there adequate fresh air supply for
combustion and ventilation?
YES NO
Vent free from restrictions? YES NO
Filter(s) secured in place? YES NO
Filter(s) clean? YES NO
Flue connections tight? YES NO
Is there proper draft? YES NO
ATTENTION INSTALLERS:
It is your responsibility to know this product better than your
customer. This includes being able to install the product
according to strict safety guidelines and instructing the
customer on how to operate and maintain the equipment for
the life of the product. Safety should always be the deciding
factor when installing this product and using common sense
plays an important role as well. Pay attention to all safety
warnings and any other special notes highlighted in the
manual. Improper installation of the unit or failure to follow
safety warnings could result in serious injury, death, or
property damage.
These instructions are primarily intended to assist qualified
individuals experienced in the proper installation of this
appliance. Some local codes require licensed installation/
service personnel for this type of equipment. Please read
all instructions carefully before starting the installation.
Return these instructions to the customer’s package for
future reference.
(03/20)
1027075A
(Replaces 10270750)