Owners manual

8
Carry More, Lift Less
©Copyright 2013
www.OxCart.com
Tow Bar Installation
1. Slide the tow bar (2) onto axle frame (1), align
with pivot hole. Refer to Figure 3.6
2.
Figure 3.6 - Tow Bar/Axle Frame
5
18
29
2
1
Insert pivot pin (5) through the top of the tow
bar and axle frame. Refer to Figure 3.6
3. Secure pivot pin with washer (18) and
cotterpin (29), use pliers to bend the cotter pin
ends to secure. Refer to Figure 3.6
Tow Bar Bumper Installation
4. Insert bolt (20) through bumper (10) and tow
bar. Refer to Figure 3.7
5.
Figure 3.7 - Tow Bar/Bed Bumper
20
10
23
21
Install washer (23) and tighten lock nut (21),
do NOT over-tighten. Refer to Figure 3.7
Bed Latch Assembly
The bed latch assembly may be pre-installed at the
factory, if assembled on your project cart, move onto
the next section.
6.
Figure 3.8 - Bed Latch Assembly Parts
13
11
22
21
23
8
7
23
Position spring (13) inside the bed latch
bracket, and insert latch (7) through the back-
side of the slot, spring, and the front-side slot.
Refer to Figure 3.9
7.
Figure 3.9 - Bed Latch Spring
13
7
11
Slide guard plate (11) onto latch. Refer to
Figure 3.9
8. Apply pressure to the latch bar to expose the
latch hole. Refer to Figure 3.10
9. Align latch handle (8) with latch hole and
insert bolt (22) and washer (23). Refer to
Figure 3.10
Figure 3.10 - Bed Latch Hole Alignment
23
21
8
22
23
APPLY PRESSURE
ASSEMBLY INSTRUCTION