Owners manual
10
Carry More, Lift Less
©Copyright 2013
www.OxCart.com
The two ends of the gas spring must be oriented
in the same direction for installation. Twist the
gas spring until bolt is aligned with the gas spring
bracket mounting hole.
The tow bar will swing if not secured, and could
cause injury or property damage.
2.
The gas spring has a high pressure rating. Do
not puncture casing.
Align the gas spring with gas spring bracket
mounting hole. The tow bar may have to be
raised or lowered to aid in alignment.
3. Insert the bolt end of the gas spring (15) into
the gas spring bracket (4) hole. Refer to Figure 3.16
4. Install nylon washer (31) and lock nut (30)
onto gas spring bolt (15). Refer to Figure 3.16
5. Using the 13mm wrench provided, hold the gas
spring bolt while tightening the lock nut.
Figure 3.16 - Gas Spring Bracket
31
4
15
30
Ensure the tow bar is supported during this process.
Axles/Wheels Installation
Before proceeding, secure the tow bar to the bed.
Carefully align and lower the tow bar into the
receiver until the tow bar latches to the bed frame.
Refer to Figure 3.17
Pinch Hazard: Ensure area between bed and
tow bar is clear of obstructions and that all personnel
are at a safe distance when securing frame.
1.
Figure 3.17 - Secure Tow Bar To Bed Frame
Press To Lock
Insert the axles (3) through the axle bushings.
Refer to Figure 3.18
2.
Figure 3.18 - Axle/Wheel Assembly
3
18
29
19
Install wheels (19) onto axles (3). Refer to
Figure 3.18
3. Secure each wheel with a washer (18), and cotter
pin (29) on each axle, use pliers to bend the
cotter pin ends to secure. Refer to Figure 3.18
ASSEMBLY INSTRUCTION