Installation Guide

BODY BAR
EASY INSTALLATION
INSTRUCTIONS
STEP 1
Remove your existing
shower head. To
remove, turn the
existing shower head
in a counterclockwise
direction.
STEP 4
In a clockwise
direction, screw fixed
unit onto the taped
portion of the diverter
and hand tighten.
STEP 2
Remove any remnants
of old plumber’s
tape and flush out
shower pipe for 5 to
10 seconds. Wrap
plumber’s tape
clockwise 3 or 4 turns
around threaded end
of shower arm.
STEP 5
Clean area BodyBar
will be applied.
Remove covering
from adhesive
strips – adhesive is
extremely powerful.
Place BodyBar in
desired location
within shower. Press
and hold firmly in
place for 30 seconds.
STEP 3
Screw the diverter
clockwise onto the
taped portion of
the shower arm.
Wrap plumber’s
tape 3 turns around
threaded ends of the
diverter.
STEP 6
Attach hex nut end of
hose to diverter and
hand tighten. Attach
conical nut end of
hose to BodyBar and
tighten.
STOP!
NEED HELP?
PLEASE DO NOT RETURN THIS
PRODUCT TO THE STORE.
If you need installation assistance, replacement
parts or have questions regarding our warranty
please contact customer service at
1.866.440.9257
or 1.775.420.5600
Support is also available via email at
[e-mail]
Be sure to visit our website at
www.oxygenics.com
Business Hours:
Monday-Thursday 7:00 am to 5:00 pm PST
Friday 7:00 am to 4:30 pm PST
For use with automatic
compensating valves
rated at 1.35 GPM
(5.11 L/min) or less.
WARNING:
ADHESIVE IS EXTREMELY STRONG
& WILL STICK ON CONTACT.
Oxygenics is not responsible for any injury or
damage resulting from improper installation,
use, or removal of the wall mount.
ATTENTION:
WASHERS PRE-INSTALLED
IN HOSE ENDS
Washers must be inserted into both
hose ends for proper installation.
USING THE DIVERTER
To change the shower spray: Place your index
finger on one lever and your thumb
on the other lever and rotate either
clockwise or counter clockwise
(depending on the current position)
until you feel it click into place.