Operation Manual

39
Channel search
The automatic search function of the receiver scans the individual
satellites or, alternatively, the DVB-T channels for new channels.
Channels already included in the channel list are automatically updated in
case of any changes. Depending on the settings in "Edit Settings Æ
General Options", encrypted channels may be ignored (see page 33).
When the mobile search is started, all DVB-T channels are first deleted
from the channel list (see page 30).
4.4.2 Searching
1. Select the search function from the main menu option "Channel
list/Channel search" in the sub-menu "Channel list" in the main
menu.
2. Select the satellite from the list (or DVB-T) that you wish to search
for new channels and confirm your selection with OK. Note that the
antenna must be aimed at this satellite and that a signal must be
received. To receive DVB-T signals, a suitable antenna must be
connected.
3.
Wait until the search has been completed. Technical details of the
scanned channels and the number of channels found are displayed. A
search may well take approx. 15 minutes.
4. After the search is completed, the channel-selection window will be
displayed.
4.4.2 Channel-selection window
This window shows the channel list on the left-hand side and the new
channels on the right-hand side. Press TV or RADIO to switch between
the TV and radio channels. Use SWAP to switch between the lists.
Several functions are available. To display these, highlight in the list the
channel you wish to change, then press OK and select an option from
the menu displayed.
If channel entries are inserted into the channel list, the selection will
change into the left-hand window and you will be prompted to select the
target entry from the list by pressing OK.