User Manual
STITCH LINE
Before you begin
Read all instructions thoroughly before beginning set up.
• Select a level site clear of rocks, branches, and other hard or sharp objects, to set up your shelter.
WARNING: Keep clear of overhead power lines.
• Do not set up your shelter under trees because of potential lightning strikes or falling tree
limbs in inclement weather.
• Secure with all stakes and guylines provided to prevent property damage or personal injury.
• Two people can easily setup this shelter in minutes.
Scan the QR code to view our “Sets up in Minutes” video.
Extend Shelter Frame
CAUTION: Avoid pinch points when
opening or closing the shelter frame.
• Expand and spread out SHELTER
FRAME. (Fig. 1)
NOTE: Only extend SHELTER FRAME
half way for easier placement of the
CANOPY.
Setup Instructions:
2
Attach Canopy
• Unfold CANOPY then drape over STEEL SHELTER FRAME. (Fig. 2)
• Locate HOOK & LOOP FASTENER on underside of the CORNER POCKET of the CANOPY. (Fig. 2)
• Attach HOOK & LOOP FASTENER to material located at the top of the STEEL SHELTER LEG. (Fig. 3)
• Repeat for remaining 3 CORNER CANOPY POCKETS. (Fig. 2 & 3)
10 x 10 INSTANT CANOPY
Fig. 2
1
(See other side for proper Staking & Take Down Instructions)
Item No. WMT-1010A
Model No. 30183
CANOPY
Fig. 1
STEEL SHELTER
FRAME
STEEL SHELTER LEG
Fig. 3
UNDERSIDE
OF CANOPY
HOOK & LOOP
FASTENERS
STEEL
SHELTER LEG
CORNER POCKET
CORNER POCKETS
ROOF PEAK
Fig. 5
4
Telescoping Steel Frame Legs
• Grasp and extend TELESCOPING LEG POLE
until the silver LOCKING
BUTTON “clicks” into
locked position.
(Fig. 6 & 7)
• Repeat for remaining 3
LEG POLES.
NOTE: When telescoping the
legs, the silver locking pin will
lock in the lowest setting fi rst.
Push in the pin and extend
the leg further to desired
shelter height. (Fig. 8)
Fig. 7
Fig. 6
LOCKING
BUTTON
3
Raising Roof Support Brackets
• Grasp the LEG POLE and push up on the ROOF
SUPPORT BRACKET until the ORANGE BUTTON
“clicks” into locked position. (Fig. 4)
• Repeat for remaining
3 ROOF SUPPORT
BRACKETS to fully
raise the ROOF PEAK.
(Fig. 5)
Fig. 4
ORANGE
BUTTON
SUPPORT
BRACKET
5
Secure Canopy to Frame
• Locate HOOK & LOOP FASTENERS along the seam of the
underside of the CANOPY; then wrap around METAL BRACE
to secure. (Fig. 9)
• Repeat for remaining 3 sides of the shelter CANOPY.
• Position the gazebo shelter in its fi nal position before
securing with stakes and guylines.
Fig. 9
HOOK & LOOP
FASTENER
METAL
BRACE
3-Stage Height
Adjustability
LOWER
HIGHEST
MEDIUM
Fig. 8